Glass fiber cloth wall thermal insulation veneer brick

When the anti-crack mortar reaches the initial setting strength, it should be properly sprayed with water for curing. After about 7 days, it can be divided and stretched according to the requirements of the drawing. The surface brick joint should not be less than 5mm. At the same time, the surface layer should be pasted with standard points to control the surface layer Wall size and wall verticality, flatness. The base layer should be moistened with water, so that it does not flow. When tiling, apply 5-8mm thick brick bonding mortar on the back of the face brick, then stick the face brick on the wall, tap lightly with a gray shovel handle to attach the line, and then use a knife to adjust the vertical seam. Pay attention to the mortar is strictly prohibited to add water during use. After 24 hours of construction at room temperature, water should be sprayed for maintenance, and the water should not be too much and should not flow. The handover of the corner bricks is 45.